Here is a worn tarav mogara. The string is deeply ingrained into the bone rim… this needs to be repaired.

Start with removing the bad piece with a tight-fitting metal pin. Pry it out gently by turning round and round with the metal pin. Clean up the hole…



Select a new one, make sure it is well-fitting!!  Or, if you are lucky and it didn’t break, then it can be re-used by rotating it over p.ex. 90°, or 180°…. Glue it, and let it dry.


Apply shaping with a hand-made mill.



Clean it up, check the hole (it may be obstructed by dried up glue) and mount a new string…

Tools

Metal pins, hand drill & hand-made mills.


Improvements

Kartar Chand & Hari Chand add a special tiny tarav mogara bridge to support the string.

Hiren Roy & Barun Roy install a differently shaped mogara.


Comments

Tarav Mogara Repair — 2 Comments

Leave a Reply to Ananda Cancel reply